Meyer Sound Self-Powered Loudspeaker Systems USM-P Series Provozní pokyny

Keep these important operating instructions.USM-P Series Self-Powered Loudspeaker SystemsOPERATING INSTRUCTIONSOPERATING INSTRUCT

10USM-1P/100-P SPECIFICATIONS Meyer Sound reserves the right to alter any specification with-out notice. Please visit our web site at www.meyersound.c

11The user panel and optional module are described on page 6 of this document.USER PANEL AND OPTIONAL MODULESUser Panel with RMS option and Polarity a

Meyer Sound Laboratories, Inc.2832 San Pablo AvenueBerkeley, CA 94702tel: 510.486.1166fax: 510.486.8356e-mail: [email protected]: www.mey

Protective earth groundTerre de protectionDie schutzerdeTierra proteccionistaFrame or chassisMasse, châssisRahmen oder chassisArmadura o chassisImport

3ENGLISH• To reduce the risk of electric shock,disconnect the loudspeaker from theAC mains before installing audiocable. Reconnect the power cord onl

Thank you for investing in the MeyerSound USM-P Series. The USM-100P andUSM-1P self-powered stage monitors arecomposed of:• one 15-inch cone driver an

Continuous voltages higher than264V may damage the unit.VOLTAGEREQUIREMENTSThe USM-P operates safely and withoutaudio discontinuity if the AC voltages

The rear panel of the USM-P has twoslots for processor modules. The top slotcontains the Audio Input and ControlModule; the bottom slot contains theop

AMPLIFIER NATURAL CONVECTIONCOOLING SYSTEMThe USM-P employs a natural convectioncooling system that depends on air flowfrom below the cabinet over the

Incorrect driver polarity impairs systemperformance and may damage the dri-vers. All Meyer Sound loudspeakers areshipped with the drivers in correctal

THE AUDIO PRODUCED BY THE SPEAKERIS DISTORTED OR COMPRESSED BUT THELIMIT LIGHT IS NOT ILLUMINATED.1. Make sure the XLR cable is securelyfastened to th