Meyer Sound SIM 3 Průvodce nastavením stáhnout pdf (Strana 13)

section 3: setup

PHYSICAL SETUP WITHOUT ROUTER

In order to operate a SIM 3 machine remotely without using a wireless router connect the computer to the SIM machine

with a CAT5 or better cable. Modern computers automatically apply an internal crossover when necessary – if using an

older computer please use a crossover cable.

1. Power up the SIM 3 machine and immediately insert the Software CD (See page 4) into the CD drive of the SIM 3

machine. This must be done the moment the SIM 3 is turned on.

If the SIM 3 boots up as usual then the CD was introduced too late. This is not a problem. Just power down the SIM 3

down (by holding the power button) without removing the CD. The next time it powers up it will automatically boot from

the CD drive.

2. The SIM 3 machine will boot and present a terminal window in the upper left corner of the display (if a monitor is

attached to the SIM 3 machine).

When setting the computer’s Ethernet adaptor properties please make sure you set the following values:

 Youshouldhaveasimilardisplay:

CAT5

Windows OS X

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Žádné komentáře

Meyer Sound SIM 3 Průvodce nastavením Strana 13