Meyer Sound MM-10 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Audio zesilovače Meyer Sound MM-10. SET UP MANUAL Travelling Exhibition from Odense City Museums Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 13
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
SET UP MANUAL
Travelling Exhibition
from Odense City Museums
DK-5000 Denmark
CARL NIELSEN
MUSIC IS LIFE
Zobrazit stránku 0
1 2 3 4 5 6 ... 12 13

Shrnutí obsahu

Strany 1 - MUSIC IS LIFE

SET UP MANUAL Travelling Exhibition from Odense City Museums DK-5000 DenmarkCARL NIELSEN MUSIC IS LIFE

Strany 2 - FLIGHTCASES

The Volume knob is placed at the upper left side of a unit.The desired level is set when the opera-tor stands before the screen and acti-vates the sen

Strany 3 - Back (B)

Front of transformerThe transformer allows the operator to use different levels of electric current. The exhibition was made to function on 230-volt c

Strany 4 - + SOUNDDIRECTION

Units, page 1Contains:• 2 x MM-4XP from Meyer Sound• 1 x MM-10ACX from Meyer Sound• 2 x PanelPlayer from IN/OUT ElektronikUnits, page 14Contains:

Strany 5 - PLAN C PLAN D

CHECKLIST OF FLIGHT CASE TECHNICAL CONTENTS ASSEMBLED UNITS8 x 1 meter Powercon – Powercon cables8 x 2 meter Powercon – Powercon cables8 x 3 meter Pow

Strany 6 - STEP BY STEP

CARLNIELSENTOURINGEXHIBITIONODENSECITYMUSEUMSKVORNINGDESIGN&COMMUNICATION,20SEPTEMBER2012FLIGHTCASE CONTENT DIMENSIONSINCM WEIGHT VAL

Strany 7 - STEP 1 STEP 2 STEP 3 ACRYLIC

UNIT 01A BUNIT 02A BUNIT 03A BUNIT 07A BUNIT 06A BUNIT 05A BUNIT 04A BFLIGHTCASE 1FLIGHTCASE 2FLIGHTCASE 3FLIGHTCAS

Strany 8 - INSTRUCTIONS

EXHIBITION PLAN + SOUNDDIRECTIONPLAN APLAN BUNIT 01BAUNIT 01BAUNIT 02ABUNIT 02BAUNIT 03ABUNIT 03ABUNIT 04ABUNIT 04ABUNIT 05BAUNIT 05ABUNIT 06BAUNIT 0

Strany 9

TRANSFORMERPLAN C PLAN DUNIT 01BAUNIT 04ABUNIT 05ABUNIT 03ABUNIT 06ABUNIT 02ABUNIT 07ABUNIT 04ABUNIT 03ABUNIT 05BAUNIT 02ABUNIT 06BAUNIT 01BAUNIT 07BA

Strany 10 - ON AND OFF VOLUME KNOB SENSOR

SET UP UNITSSTEP BY STEPFOOT STANDSSIDESSIDESBOTTOM PARTOF UNITTOP PARTOF UNIT

Strany 11 - 110-VOLT SOURCE

Open the flight case. Remove the sides and inner partitions. Then remove the lower section of the unit.Remove the foot stands and attach them to the b

Strany 12 - OF EACH UNIT

Two electrical sockets have been installed under every unit. Two sets (blue and grey) have been installed on each side of the unit. The blue socket is

Strany 13 - CHECKLIST OF FLIGHT CASE

To make a connection to the next stand, plug a cable into one of the grey sockets mounted on either side of the bottom of the unit. Assembly of top an

Komentáře k této Příručce

Žádné komentáře